Common problems and solutions of PVC industrial conveyor belt
1、 Broken conveyor belt
Conveyor belt in a long time after use, the strength will be worse. Or because of the poor environment, the conveyor belt encountered water, low temperature environment, become hard and brittle. If the quality of the joint is poor and the local cracks are not repaired in time, the probability of broken belt will be greatly increased. Solution: choose high quality material with stable mechanical and physical properties to make belt core. When the conveyor belt is damaged or aged, it should be replaced in time. It is also necessary to observe the joints frequently and deal with the problems in time.
2、 Belt deviation
Fault cause analysis and solution: the frame and roller are not adjusted straight. Solution: adjust the roller or frame to keep it straight. The axis of idler is not perpendicular to the center line of conveyor belt. Solution: adjust the position of idler to correct the deviation of conveyor belt. The joint of the conveyor belt is not perpendicular to the center line, and the side of the conveyor belt is S-shaped. Solution: make the joint of the conveyor belt again to ensure that the joint is perpendicular to the center of the conveyor belt. The loading point is not in the center of the conveyor belt (partial load). Solution: adjust the location of ore fall.
3、 Belt slipping
Fault cause analysis and solution: the conveyor belt load is too large, resulting in insufficient tension. Solution: readjust tension or reduce traffic. The friction coefficient between the driving drum and the conveyor belt will be reduced after water pouring, and the conveyor belt will be transported downward. Solution: to avoid long-term wet water conveyor belt, and increase the tension. Observe the joint irregularly and deal with the problem in time.
4、 Belt aging and tearing
Failure cause analysis and solutions: conveyor belt laying too short, resulting in more than the limit of bending times, leading to premature aging. Solution: try to avoid short distance laying. The conveyor belt and fixed hard objects cannot be placed together to avoid tearing. Solution: avoid the conveyor belt hanging on the fixed component, or the metal structure falling into the conveyor belt. When the conveyor belt deviates and rubs against the frame for a long time, it will cause the side of the conveyor belt to be roughened or cracked. Solution: Dilong industrial belt recommends that the belt should be adjusted in time after deviation, so as to prevent the belt from falling off the idler when deviation is serious, resulting in shutdown. Improper storage and excessive tension. Solution: according to the conveyor belt storage requirements.
So the above is the introduction to the common problems and solutions of PVC industrial conveyor belt brought by this issue. I believe you have a certain understanding of the content after reading our article. We need to pay attention to our conveyor belt after a long time of work, If there is a problem found in the case to deal with it in a timely manner.