+86-576-83366690

Installation skills of rubber synchronous belt

Jun 01, 2021

1. When installing the vulcanized rubber synchronous belt, if the center distance of the two pulleys can be moved, be sure to reduce the center distance of the pulleys first, and then calibrate the center distance after installing the synchronous belt.

2. When using the drive belt on the pulley, remember not to use too much force, or use a screwdriver to pry the synchronous belt hard, so as to avoid the fracture of the tensile layer in the drive belt that cannot be detected. When designing the pulley, it is better to adopt the structure that the two shafts can move close to each other. If the structure is not allowed, it is better to install the transmission belt and pulley together on the corresponding shaft.

3. Control moderate initial tension distance.

4. In the vulcanized rubber chain drive, the flatness of the center line of the two pulleys is relatively high, otherwise the synchronous belt will cause the direction deviation and even jump out of the pulley when it is working. If the center line is far away from the parallel plane, the working pressure will be uneven, which is the initial damage of the belt teeth.

5. The sound card frame supporting the point pulley must have sufficient bending stiffness, otherwise the pulley will cause the uneven surface of the two center lines when the password padlock is running.


Send Inquiry